LPT Driver
(ver 0.6)
Abandoned Freeware


LPT Driver is a program for powering devices through a LPT port (parallel 
"CENTRONICS"). It allows you to easily change the logic states of any pins. 
With a small electronic circuit we can, for example, drive electric devices 
through the PC. The program can support a maximum of 24 devices... 
i.e.: 3 LPT ports (0x287, 0x387, and 0x3BC), with 8 pins on each port.

Typing the filename (LPTDRV.EXE) will start LPT Driver in interactive mode
(push "ESC" to exit).  Starting the program with the "/Auto" switch, will
put the program into automatic mode (it reads the file "LPTDRV.CFG"). In 
"LPTDRV.CFG" you can specifiy the Port, Pin, and State to set, and you can
have them changed at a specific date (year/month/day or daily) and time 
(hour/minute/second). 


There is no need to build an additional electronic circuit for small power 
devices like LEDs (10-20mA), but for bigger projects (motors, etc.), a relay  
circuit is needed. Included are two relay circuit diagrams...One for a 6v 
device and one for a 120v device.  


file = LPTDRV.zip


====================

NCD
(ver 1.0)
Abandoned Freeware


Included here as a complement to LPT Driver is "NCD.exe for DOS".  
NCD is a COM (serial) port controller for many of the serial port relays 
and devices sold by "National Control Devices" (http://www.controlanything.com/).  

Devices supported include:
	ASEL
	8S2S
	AVS4X1
	E3C
	IOADR8X
	IOADR16X
	IOCONTROLLER
	MSERVO
	PWM8X
	R16X
	R1X
	R2X
	R32X
	R4X
	R8XPRO
	SSR8X
	SERVOCONTROLLER
	STP


file = NCD.zip